Ticket #13009: ea-n66-56u-openwrt.txt

File ea-n66-56u-openwrt.txt, 4.3 KB (added by me@…, 3 years ago)

EA-N66 boot on OpenWrt AA b1 for RT-N56U

Line 
1
2
3
4U-Boot 1.1.3 (Jun  7 2012 - 15:51:58)
5
6
7Board: Ralink APSoC DRAM:  32 MB
8
9relocate_code Pointer at: 81b7c000
10
11flash_protect ON: from 0xBC000000 to 0xBC02166B
12
13flash_protect ON: from 0xBC030000 to 0xBC030FFF
14
15*** Warning - bad CRC, using default environment
16
17
18  Scan PHY Finish, set Addr to 00
19
20
21 Realtek 8211 phy
22
23reg 5 is 8b84
24
25reg 6 is 52b
26
27============================================
28
29Ralink UBoot Version: 3.6.0.0
30
31--------------------------------------------
32
33ASIC 3883_MP (MAC to GigaPHY Mode)
34
35DRAM component: 256 Mbits DDR, width 16
36
37DRAM bus: 16 bit
38
39Total memory: 32 MBytes
40
41Flash component: NOR Flash
42
43Date:Jun  7 2012  Time:15:51:58
44
45============================================
46
47icache: sets:512, ways:4, linesz:32 ,total:65536
48
49dcache: sets:256, ways:4, linesz:32 ,total:32768
50
51
52 ##### The CPU freq = 500 MHZ ####
53
54 estimate memory size =32 Mbytes
55
56
57Please choose the operation:
58
59   0: Load Boot Loader code to SDRAM via Serial.
60
61   1: Load system code to SDRAM via TFTP.
62
63   2: Load system code then write to Flash via TFTP.
64
65   3: Boot system code via Flash (default).
66
67   4: Entr boot command line interface.
68
69   7: Load Boot Loader code then write to Flash via Serial.
70
71   8: Load Boot Loader code to SDRAM via TFTP.
72
73   9: Load Boot Loader code then write to Flash via TFTP.
74
75 1 0
76
77   
78
793: System Boot system code via Flash.
80
81
82before LEDON:
83
84data:1f
85
86Do bootm
87
88## Booting image at bc050000 ...
89
90   Image Name:   MIPS OpenWrt Linux-3.3.8
91
92   Created:      2012-09-03  22:35:40 UTC
93
94   Image Type:   MIPS Linux Kernel Image (lzma compressed)
95
96   Data Size:    910742 Bytes = 889.4 kB
97
98   Load Address: 80000000
99
100   Entry Point:  80000000
101
102   Verifying Checksum ... OK
103
104   Uncompressing Kernel Image ... OK
105
106No initrd
107
108## Transferring control to Linux (at address 80000000) ...
109
110## Giving linux memsize in MB, 32
111
112
113Starting kernel ...
114
115
116[    0.000000] Linux version 3.3.8 (blogic@Debian-60-squeeze-64-minimal) (gcc version 4.6.3 20120201 (prerelease) (Linaro GCC 4.6-2012.02) ) #2 Mon Sep 3 22:35:21 UTC 2012
117[    0.000000] bootconsole [early0] enabled
118[    0.000000] CPU revision is: 0001974c (MIPS 74Kc)
119[    0.000000] Ralink RT3883   ver:1 eco:5 running at 500.00 MHz
120[    0.000000] Determined physical RAM map:
121[    0.000000]  memory: 02000000 @ 00000000 (usable)
122[    0.000000] Initrd not found or empty - disabling initrd
123[    0.000000] Zone PFN ranges:
124[    0.000000]   Normal   0x00000000 -> 0x00002000
125[    0.000000] Movable zone start PFN for each node
126[    0.000000] Early memory PFN ranges
127[    0.000000]     0: 0x00000000 -> 0x00002000
128[    0.000000] Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 8128
129[    0.000000] Kernel command line:  board=RT-N56U console=ttyS1,57600 mtdparts=physmap-flash.0:192k(u-boot)ro,64k(u-boot-env)ro,64k(factory)ro,896k(kernel),6976k(rootfs),7872k@0x50000(firmware) rootfstype=squashfs,jffs2
130[    0.000000] PID hash table entries: 128 (order: -3, 512 bytes)
131[    0.000000] Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
132[    0.000000] Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
133[    0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
134[    0.000000] Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
135[    0.000000] Writing ErrCtl register=00000000
136[    0.000000] Readback ErrCtl register=00000000
137[    0.000000] Memory: 29708k/32768k available (2104k kernel code, 3060k reserved, 356k data, 168k init, 0k highmem)
138[    0.000000] SLUB: Genslabs=9, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
139[    0.000000] NR_IRQS:140
140[    0.000000] console [ttyS1] enabled, bootconsole disabled
141[    0.000000] console [ttyS1] enabled, bootconsole disabled
142[    0.010000] Calibrating delay loop... 249.44 BogoMIPS (lpj=1247232)
143[    0.080000] pid_max: default: 32768 minimum: 301
144[    0.080000] Mount-cache hash table entries: 512
145[    0.090000] NET: Registered protocol family 16
146[    0.100000] MIPS: machine is Asus RT-N56U
147[    0.110000] gpiochip_add: registered GPIOs 0 to 23 on device: RT3883-GPIO0
148[    0.120000] gpiochip_add: registered GPIOs 24 to 39 on device: RT3883-GPIO1
149[    0.130000] gpiochip_add: registered GPIOs 40 to 71 on device: RT3883-GPIO2
150[    0.140000] gpiochip_add: registered GPIOs 72 to 95 on device: RT3883-GPIO3