source: trunk/target/linux/generic/patches-2.6.36/620-phy_adm6996.patch @ 26865

Last change on this file since 26865 was 26865, checked in by blogic, 6 years ago

[PATCH v3] (respin) 802.1Q VLAN support for ADM6996M/ADM6996FC

This patch adds 802.1Q VLAN support for the ADM6996M chip.

The driver is loaded for both the FC and M model. It will detect which of the
two chips is connected. The FC model is initialised, but no further
functionality is offered.

The PHY driver will always report "100 Mbit/s, link up", for both the M and FC
models. This reflects the fact that the link between switch chip and Ethernet
MAC is always on[1].

Further documentation can be found in the kernel's
Documentation/networking/adm6996.txt

Signed-of-By: Peter Lebbing <peter@…>

File size: 860 bytes
  • drivers/net/phy/Kconfig

    a b config MICREL_PHY 
    9393        ---help--- 
    9494          Supports the KSZ9021, VSC8201, KS8001 PHYs. 
    9595 
     96config ADM6996_PHY 
     97        tristate "Driver for ADM6996 switches" 
     98        select SWCONFIG 
     99        ---help--- 
     100          Currently supports the ADM6996FC and ADM6996M switches. 
     101          Support for FC is very limited. 
     102 
    96103config FIXED_PHY 
    97104        bool "Driver for MDIO Bus/PHY emulation with fixed speed/link PHYs" 
    98105        depends on PHYLIB=y 
  • drivers/net/phy/Makefile

    a b obj-$(CONFIG_VITESSE_PHY) += vitesse.o 
    1313obj-$(CONFIG_BROADCOM_PHY)      += broadcom.o 
    1414obj-$(CONFIG_BCM63XX_PHY)       += bcm63xx.o 
    1515obj-$(CONFIG_ICPLUS_PHY)        += icplus.o 
     16obj-$(CONFIG_ADM6996_PHY)       += adm6996.o 
    1617obj-$(CONFIG_REALTEK_PHY)       += realtek.o 
    1718obj-$(CONFIG_LSI_ET1011C_PHY)   += et1011c.o 
    1819obj-$(CONFIG_FIXED_PHY)         += fixed.o 
Note: See TracBrowser for help on using the repository browser.